Powder bulk density meter

Introduction

HTD-16913 is designed and produced based on GB/T 16913.3-199.it is application to measuring bulk density of powder.

Principle

The powder drop from high place freely and fill with measuring cylinder; By measuring the gram mass and volume in the status of loose. can get bulk density.

Structure

1.Funnel(diameter of outflux 12.7mm)

Stainless steel funnel(304), 60°±0.5° taper

2.Obstructed rod

Stainless steel(304),to prevent the dust drop when placed into funnel

3.Measuring cylinder

100ml stainless steel(304) measuring cylinder.inner diameter Φ39mm

4.Scraper blade

Stainless steel(304),to remove the extra dust when it is droped into funnel

Measuring step

1. Test the weight of the empty stainless steel measuring cup m1

  2. Block the funnel with a plugging bar and weigh some powder into the funnel.

3. Unplug the plug and let the powder free downstairs until the powder completely overflows the measuring cup

4. Squeeze the excess powder of the measuring cup with a stainless steel ruler, and then weigh the weight of the measuring cup and the powder at this time.

5. Calculate the bulk density of the powder according to the formula: ρ = (M2-M1) / V Remarks: V-corrected cylinder volume, 100 cm3.

Remarks: The difference between the maximum and minimum values of the dust quality measured for three consecutive times should be less than 1g, and the average of the three measurements that meet the requirements is taken as the measurement result.

Standard configuration

Density meter

Blocking rod

Cylindrical measuring cup

Scraper

Brush